Türkçe
العربية
3465 Quality Sheet Specification
Soğuk Şekillendirmeye Uygun, Yüksek Akma Dayanımlı, Sıcak Haddelenmiş Çelikler
AlternativesThere is no alternative to this sheet.
Flat / Hot Rolled
Flat steel products are obtained by heating semi-finished products with a rectangular cross-section (slab), which are produced by the continuous casting method, to a specific temperature and then rolling them, with thicknesses ranging from 1.40 to 25.40 mm and widths ranging from 700 to 2025 mm, produceed as coil or by cutting/slit-coiling flat steel products from coils.
Soğuk Şekillendirmeye Uygun, Yüksek Akma Dayanımlı, Sıcak Haddelenmiş Çelikler
Chemical Composition (%)
| Standard Equivalent | Erdemir Grade No | Cmax. | Mnmax. | Pmax. | Smax. | Crmax. | Momax. | Nimax. | Vmin. | Nbmin. | Timin. | Cumax. | |
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| Standard | Quality | ||||||||||||
| ASTM A1018-2025 | Gr. 65 Class 1 | 3465 | 0.26 | 1.50 | 0.04 | 0.04 | 0.15 | 0.06 | 0.20 | 0.005 | 0.005 | 0.005 | 0.20 |
- When copper is requested in the chemical compositon, value specified in the table will be evaluated as minimum value. When copper is not specified, the copper limit is a maximum requirement.
- For each reduction of 0.01 percentage point below the specified max C an increase of 0.06 percentage point above the specified max for Mn is permitted up to a max of 1.50% by heat analysis
- V,Nb or Ti elements can be added either individually or any combinations specified in the table.
Mechanical Properties
| Standard Equivalent | Erdemir Grade No | Re [N/mm2] | Rm [N/mm2] | A(%) min. t(thickness, mm) | Bend (Transverse , BMD) t: thickness | ||
|---|---|---|---|---|---|---|---|
| Standard | Quality | ||||||
| A506.01≤t≤19 | A20019.01≤t≤20 | 180° | |||||
| ASTM A1018-2025 | Gr. 65 Class 1 | 3465 | 450 min. | 550 min. | 14 | 22 | R 2d |
- Tensile test values apply to "transverse" test pieces
- The bending test is carried out only when specified at the time of enquiry and order.