6110 Quality Sheet Specification
General application steels for cold forming (Galvanizing, office equipment, lighting devices, etc.)
AlternativesThere is no alternative to this sheet.
Flat / Cold Rolled
Cold rolled coils or flat steel products are produced by rolling hot rolled flat steels without a heat treatment operation in a thickness range of 0.20 to 2.00mm. While the product’s physical properties are all homogeneous along the strip, surface flatness, width and thickness values have fulfilled expectations at the top level.
General application steels for cold forming (Galvanizing, office equipment, lighting devices, etc.)
- Mechanical test is not carried out
- The limitation requests for the residual elements (Cu, Ni, Cr, Mo) which are not mentioned on the table are subjected to negotitation for special application purposes.
- Mn content is not specified in SAE standard. In ERDEMIR Mn content is aimed to minimum 0.20.
- Tensile test values are measured in the longitudinal direction in accordance with A 370 Test Methods and Definitions
- Mechanical properties specified in the table are reference values only for guidance.
Soğuk Haddelenmiş Karbon Çeliği
- Mechanical test is not carried out
- The limitation requests for the residual elements (Cu, Ni, Cr, Mo) which are not mentioned on the table are subjected to negotitation for special application purposes.
- Mn content is not specified in SAE standard. In ERDEMIR Mn content is aimed to minimum 0.20.
- Tensile test values are measured in the longitudinal direction in accordance with A 370 Test Methods and Definitions
- Mechanical properties specified in the table are reference values only for guidance.
Türkçe
العربية