6356 Quality Sheet Specification
Dual certified hot rolled normalized fine grained steel suitable for pressure purposes
AlternativesThere is no alternative to this sheet.
Flat / Hot Rolled
Flat steel products are obtained by heating semi-finished products with a rectangular cross-section (slab), which are produced by the continuous casting method, to a specific temperature and then rolling them, with thicknesses ranging from 1.40 to 25.40 mm and widths ranging from 700 to 2025 mm, produceed as coil or by cutting/slit-coiling flat steel products from coils.
Dual certified hot rolled normalized fine grained steel suitable for pressure purposes
- Cu + Cr + Mo ≤ 0.45 %
- (Nb + V + Ti) ≤ 0.12%
- Al/N ≥ 2
- Minimum value for aluminium does not apply if the chemical composition includes additionally Nb, Ti or V.
- Suitable for dual certification.
- Depending on agreement, Cu + 6Sn ≤ 0,33 %
- Tensile test values apply to "transverse" test pieces
- The tensile test for proof strength at elevated temperature is carried out on request.
- Impact test is not carried out for thickness thinner than 6 mm.
Dual certified hot rolled normalized fine grained steel suitable for pressure purposes
- Cu + Cr + Mo ≤ 0.45 %
- (Nb + V + Ti) ≤ 0.12%
- Al/N ≥ 2
- Minimum value for aluminium does not apply if the chemical composition includes additionally Nb, Ti or V.
- Suitable for dual certification.
- Depending on agreement, Cu + 6Sn ≤ 0,33 %
- Tensile test values apply to "transverse" test pieces
- The tensile test for proof strength at elevated temperature is carried out on request.
- Impact test is not carried out for thickness thinner than 6 mm.
Flat / Plate
Heavy plate products are obtained by rolling semi-finished products with a rectangular cross-section (slab) produced by the continuous casting method to a specific temperature, with thicknesses ranging from 6.00 to 200.00 mm and widths ranging from 1000 to 3600 mm.
Dual certified hot rolled normalized fine grained steel suitable for pressure purposes
- Cu + Cr + Mo ≤ 0.45 %
- (Nb + V + Ti) ≤ 0.12%
- Al/N ≥ 2
- Minimum value for aluminium does not apply if the chemical composition includes additionally Nb, Ti or V.
- Suitable for dual certification.
- Depending on agreement, Cu + 6Sn ≤ 0,33 %
- Tensile test values apply to "transverse" test pieces
- The tensile test for proof strength at elevated temperature is carried out on request.
- Impact test is not carried out for thickness thinner than 6 mm.
Dual certified hot rolled normalized fine grained steel suitable for pressure purposes
- Cu + Cr + Mo ≤ 0.45 %
- (Nb + V + Ti) ≤ 0.12%
- Al/N ≥ 2
- Minimum value for aluminium does not apply if the chemical composition includes additionally Nb, Ti or V.
- Suitable for dual certification.
- Depending on agreement, Cu + 6Sn ≤ 0,33 %
- Tensile test values apply to "transverse" test pieces
- The tensile test for proof strength at elevated temperature is carried out on request.
- Impact test is not carried out for thickness thinner than 6 mm.
Türkçe
العربية